After another 20 minutes we returned and removed all the remaining Danish Oil from the surface with a clean rag: After another hour we wiped the board again, although there were no obvious signs of surface oil at this stage and the board was dry to the touch, with a pleasant low sheen finish. Before and after applying Danish Oil ‘wet on wet’ The key thing to consider here, is how the price of Colron Refined Jacobean dark oak Danish oil 0.5L compares to others but taking into account the quality and features of Colron Refined Jacobean dark oak Danish oil 0.5L over the other options.

However, we then like to go a little deeper to explore more detail about the product by looking at products in the same category as Colron Refined Jacobean dark oak Danish oil 0.5L. That then tells us that there are 4480 products in the Painting & Decorating category at B & Q. Apply the Danish Oil liberally with a clean, lint-free cloth or natural bristle brush, and wipe off any surplus oil after a few minutes Danish Oil may be applied to previously oiled surfaces. On previously stained or dyed surfaces it is advisable to test a small area first to make sure that the Danish Oil will produce the desired result. To ensure proper drying the temperature should be above 10 Degrees C and Danish Oil should not be applied in damp conditions. Do not apply in direct sunlight.

Colron Refined Jacobean dark oak Danish oil 0.5L Reviews

This method is suitable when working on large areas, or when there is a limited amount of time available for oiling each day. The idea of this method is to keep the wood surface’wet’ with Danish Oil for at least an hour until it has fully absorbed enough oil to provide a natural protective coating from deep within the wood.

Any ‘nibs’ or dust on the surface of the wood during oiling cannot be removed with this method of application until the wood has been left to dry for at least 24 hours. The particles should then be removed with a very fine grade wire wool (oooo grade). Barrettine Danish Oil should be applied at a room temperature of between 15°C - 25°C Do not apply below 5°C. Stir / shake well before use.

Application during the second day was the same as the first. Danish Oil was applied until the wood stopped absorbing. After 20 minutes all excess oil was removed with a clean rag. Our Danish Oil is based on Tung Oil, and is a penetrating oil which will ‘feed’ and protect wood. Varnished, shellaced, lacquered or heavily stained wood will usually present a surface barrier to absorption of the Danish Oil, and will need to be removed as necessary with a proprietary paint stripper. The photograph below was taken at a low angle to show the low sheen finish after application and finishing with Danish Oil. Finished Waxed finishes, and all dirt and grease, should be removed with white spirit on a rag using vigorous agitation.