Always test product on a spare surface or inconspicuous area for colour, compatibility and end result. Do not apply to hot surfaces. Essentially, the main aim of any desoldering job is to cleanly remove melted material (be it wire, flux or paste) from the location you are working on, such that the component can be reseated and a better bond can be created at the next attempt. As such, the three basic steps in any desoldering operation will be as follows:

Allow to dry for a minimum of four hours before buffing with a brush or cotton cloth. If more coats are required, you can re-apply to get a better finish. For cleaning and maintenance, Re-apply and buff as necessary as this will further protect and enhance the finish.

You may also like...

Ensure that the surface is clean and free from rust, using a rust remover if necessary. Apply the Iron Paste sparingly with a brush or cotton cloth. To achieve a decorated, patinated finish on sculpted or high relief pieces, carefully polish the raised area with a cotton cloth. Always wear protective gloves when working with this product and do not apply to a hot surface. Any accidental spillage of food or drinks should be mopped up immediately with an absorbent cloth and the affected area cleaned and polished with a soft brush to reinstate the shine and the protective layer to prevent surface rust appearing. Liberon Iron Paste is especially ideal for use when restoring and renovating cast iron fire places and surrounds. Once it is all dry rub the fireplace with a cotton cloth gently all over to give it a really nice finish. Please note that this is a decorative finish and is not suitable for use on surfaces that are liable to be subject to intense heat.

The mixture fulfils neither the PBT nor the vPvB criteria for mixtures in accordance with annexe XIII of the REACH regulations EC

How to use Liberon Iron Paste

Apply Iron Paste sparingly to the whole surface with a brush or cotton cloth. For awkward areas, a small toothbrush is ideal. Lightly buff off any excess and leave to fully dry. Under no circumstances should a damp cloth, water or water based cleaners, or water based polishes, be used to clean cast iron products By following these simple instructions to clean and protect your cast iron appliance it will retain its distinctive natural beauty and aesthetic appeal and provide you with many years of trouble free service.

Apply the Iron Paste sparingly to the whole surface with a brush or cotton cloth. Allow to dry for a minimum of 4 hours before buffing with a brush or cotton cloth. There are numerous reasons why you might need to desolder an existing bond between components or workpieces.

Metal Treatments

The basic process of soldering is broadly seen as fairly simple and straightforward. However, knowing exactly how and when to use a soldering iron for the best possible results is something that professional engineers continue to develop over years of dedicated use, and learning the proper techniques for achieving a neater, more effective join can demand a significant level of finesse and experience. The mixture does not contain substances classified as ‘Substances of Very High Concern' (SVHC) = 0.1% published by the European