When the surface is thoroughly dry the affected surface will need to be rubbed down using 'wet and dry' abrasive paper. It can then be re-coated. This should only be done once the conditions improve or when the condensation problem is resolved.

This is caused by painting over contaminated surfaces such as wax, oil or polish. The paint cannot adhere to the surface and draws away leaving unpainted areas. This can also be caused by contamination on the brush. Putting it rightSecondly, because Polyfilla is a porous material, it may absorb some paint and produce a slightly mottled effect. To prevent this, use a primer before painting to seal the surface and provide a smooth base for your topcoat. Depressions or surface blemishes in the paint film. A common cause is rain that has fallen on the surface before the film has had chance to fully dry. Putting it right Adding a second coat of paint will get rid of streaks left by rollers. You can make the job more seamless by taking a brush and going over the streaky areas to smooth out. Improper mixing: If you’ve mixed the filler incorrectly, it may not have the right consistency to dry properly. The Polyfilla must be kept from direct sunlight in a cool and dry place with temperatures under 70°F (21°C). To further help maintain the product’s lifespan, make sure that the lid is properly sealed after each use

Overall, the drying time for Polyfilla depends on various factors such as temperature and humidity. It generally takes 30 minutes to an hour for Polyfilla to dry in normal conditions. The first job is to sand them with a coarse grade of sandpaper to get off the worst of the lumps and bumps, followed by a medium grade sandpaper. Next,...

This is a common occurrence in new houses and is often the result of plaster drying out or movement of the building. Putting it right

Make sure that all filled areas are rubbed down smooth and level. You will need to prime the filler before painting to prevent subsequent coats being absorbed more rapidly than on other areas. Use a coat of Dulux emulsion thinned 10-20% with clean water. Once this is dried you can apply a full coat of Dulux emulsion.in 1 mould killer is designed to kill the existing mould and spores that will create new growth. Some moulds stain the area they grow on. 3 in 1... However, if you need your project done faster, special fast-drying versions can be ready within 15 minutes or less. Mixing Polyfilla powder is relatively easy, requiring minimal tools and materials. To begin, you will need to gather the following: Affected areas should be treated with Weathershield Multi-Surface Fungicidal Wash. Once rinsed and allowed to dry it can be over coated with your favourite Weathershield Masonry Paint. Oscillating paint scraper (Multi-tool) – Produces rapid circles from a tight and controlled motion. Overall, is a faster and an easier on the arms approach to dealing with peeling paint.