It consists of two (2) extruded aluminium parts which even when the handle is locked on the fence rail still result in the fence ending up with considerable and unacceptable deviation from true (i. Sorry Tom I thought you meant the fence moved that much when locked , When I put my fence on to saw it slides along front channel smoothly and is held with the two white nylon pads it can move slightly at the rear but when you clamp the fence up it should be straight from front to back . Factor in its wheels and foldability for easy job site portability too, and it’s an invaluable all-rounder. We manufacture the saw blade slot with only 4-5 mm width, so that the saw blade and the saw wedge fit through.

When cutting steel, it leaves an instantly workable finish, producing no heat, no burr and virtually no sparks - unlike alternative methods (shown above). Features a rip fence that is solid and sturdy in every position for essential cutting security, furthermore, the included anti-bounce device minimises material movement. If you’d like to file an allegation of infringement, you’ll need to follow the process described in our Copyright and Intellectual Property Policy.The result is better cutting quality on the underside of the workpiece, as the workpiece is supported from below up to the saw blade teeth and tearing is significantly reduced. Only downside - as others have noted - is the flimsy fence - fine for light work (like the pine strips) but for heavier jobs, a piece of aluminium angle and a couple of clamps sorted it out. It is my view that the manufacturers must replace the current disappointing design with a system that once set parallel to the blade remains true.

I have the Screwfix 'sister' saw to this - the R255 PTS - when the fence is not locked, it also can swivel slightly like that. Perfect for cutting through all sheet materials including hard and soft wood, metal, plastic and more! We will not share, sell or disclose your information to any third party for any reason without your consent, except as required by law. Given the way the fence attaches, I don't know that you'll ever totally avoid that - it locks by pulling at the back, which pulls the front of the fence with the black 'square' bit in tight against the rail that the fence runs on, but when loosened it just lifts on/off that rail - it doesn't 'run' in the rail as such if that makes sense?Machine Mart Limited is authorised and regulated by the Financial Conduct Authority, register number 703528 and acts as a credit broker and not a lender. The table insert is manufactured with clearances, on either side of the blade, which allow strips of the material that is being cut to enter the blade hanger frame and dust cover assembly and end up resting on its bottom. The blade provided was found to work very well with wood, plywood, MDF (all of different thickness). The FURY 5-S provides tremendous cutting versatility including, cross cut, mitre cut, bevel cut, straight cut for large or small applications.