Cut the bigger shrinking tube about half of the total length from the resistor to the needles and insert it over the two wires leaving only the two needles out. I have been struggling to find information due to the sheer amount of different vehicles and all the results I can find are either for newer models or for pretensioners on the receiver stalk rather than on the belt.

This video will show you step by step instructions on how to make a DIY airbag tester so you can test your airbag without the need for an expensive airbag tool. So you didn’t know all this and your airbag warning light is already on? Don’t panic, they can always be turned off. Again it’s time to do your research online because, depending on your car, sometimes you can get away with resetting the light yourself by following a certain procedure of key-turning or pressing buttons in a specific sequence. For the most part though you’ll either need a specialist diagnostic scanner to do the job or will have to take a trip to a local garage and hand over a few quid. Steer clear of the main dealers for this – most will really pull your pants down on the price. I took it to the dealer to get the crash module reset - this stopped the hazards turning on when I turned the ignition on. They also said the following fault codes were present:

Best Engine Coolant In 2023

Il aide au diagnostic d'un airbag défaillant, d'un ressort d'horloge d'airbag et de tendeurs de ceintures de sécurité défaillants, etc. If you use a push-pin, cut it so the two tips of the push-pin are sharp. if you use sewing needles you can just leave them as they are. It desperately needs to go for an MOT soon as it has expired and is parked on the road. I do not know anyone who would turn a blind eye to the airbag light being on. Put some of the smaller heat shrinking tubes over the soldered portion of the needles and the resistor. You can test your resistor first to make sure it suits your needs. It should be between 2 and 2.4-2.6 ohms.)

Once the resistor tool is set at the correct resistance value, then the codes will erase and the airbag light will remain off which indicates you have found the correct resistance value that should be in that circuit. Mod Details Premium Yes Difficulty Mod ID 1104 Credit evilution For Link https://www.evilution.co.uk/mod/airbag-delete-resistor.htm Copy to Clipboard If your not sure if either pretensioner is functional you can test them with a volt/ohm meter as shown at https://www.youtube.com/watch?v=dsOM58mBM7YHi. I have a 2005 Expert which has the airbag light on. It has the seatbelt pretensioners on the belt itself in the B pillar and drivers airbag only. Maybe you keep having an airbag light come on, perhaps you have fitted an aftermarket steering wheel, maybe you are tired of the seat side airbag connections failing. Of course, there are other possibilities such as wishing to use aftermarket seatbelt reels or you don’t want to pay for an airbag but you want the car to pass an MOT.