In that case, nothing would happen. However, the sound engineer who mixed the audio would be annoyed.

The speaker wire is usually marked in some way so that you know which is the same wire at each end.

You can only compare up to four products at a time.

Banana plug pins are a standard 4mm in diameter, just right to fit into the end of a binding post. Using Spade Connectors

Did I mention earlier in this supposed review that Russell was bringing the Red 50s along with him? Well yes, indeed he did. Crimping is where you use a tool to bend the connector’s end so that it clasps tightly to the wire, and it can be a good solution if you don’t want to get involved in soldering the wire. You could also use them with binding posts by inserting them through the central hole in the post – and then tightening the cap. But it’s not the usual way of using this type of connector. Odd that the volume was muted to start with but maybe i bumped the side button and muted the audio during the configuration Pull the positive and negative wires apart – by about 1 or 2 inches – so you have some separation to work with. You might need a sharp knife to split the central insulation – or it will just pull apart if you apply enough pressure. Ensure you don’t cut into the insulation and expose bare wire further down the cable; you just want to expose the wire at the end.Make sure you connect the same piece of wire to the positive and negative terminals on the amplifier and speaker.