Spyderco CBN Benchstone Double Sided Sharpener Cubic Boron Nitride

Product Information

Ich ziehe die Klinge anschließend noch mit einem gelben belgischen Brocken ab, um eine hochglänzende Schneide zu erhalten. It never requires flattening (though in all fairness neither do diamond stones) and it will sharpen any tool steel, including the S90V produced by Crucible. That is interesting but perhaps you could share more information and someone aside from Cliff may have some insight? This is more noticeable with lower grits as the abrasive particles are larger, as you move to finer grits you're less likely to see the difference unless you are really looking for it. Pefekte Ergebnisse, einfache Handhabung, die Steine liefern in den gelieferten Abstufungen alles was man zum durchschleifen braucht.

Burr based sharpening is more common and produced better results from the testing I've personally done so far. CBN Sharpening Stones consists of a 2 mm thick CBN-bearing plate mounted on a high-quality aluminum blank.You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice. So far this is the best setup I have found, with very repeatable results sharpening the same head after use. And the grit rating seems to be finer than how they're marked, (mine anyway) seem to cut and feel like something less aggressive than their designation states.

Assuming the bond strength is not excessive they will renew themselves with fresh, unworn (and most importantly SHARP) abrasive particles which continue cutting rapidly. Metallic CBN Sharpening Stones from Poltava Diamond Tools are used for sharpening knives using guided knife sharpeners (Hapstone, TSPROF, and other Edge Pro-compatible sharpening systems). When you flatten them use the coarsest powder then move to a powder that's halfway between the stones grit then finish using a powder the same grit or 1 grit lower.CBN offers high performance, sharpens any steel, has a low wear rate and little loading, creates no mess and makes no unwanted grooves. Multipurpose - The broad, perfectly flat carbon steel embryo is coated with fast-cutting 400-mesh CBN on one side and finer 800-mesh CBN on the other. What I refer to as scratchy is, after using the Matrix stones from Edge Pro starting with the 80 to the 4000, the finished edge has a polish to it. And 800 grit + 3 micron strop should provide a very nice working/long lasting edge, no need for anything much higher (again, not worried about getting mirror polished egdes). I used the 306CBN on a range of O1, A2 and PM-V11 chisel and plane blades, and was very pleased with its performance.