Waveshare Ethernet Module, High-Performance 10/100 Ethernet Physical Layer Transceiver (PHY)

Product Information

EMAC_TXD0, EMAC_TXD1, EMAC_TX_EN, EMAC_RXD0, EMAC_RXD1, EMAC_RX_DV and EMAC_TX_CLK are fixed and can't be rerouted to other GPIOs. I made a small prototype for the eBox ESP32-T and the Waveshare LAN8720 ETH Board which already has an 50MHz oscillator.

Add commands ``ChannelRemap``, ``MultiPWM``, ``AlexaCTRange``, ``PowerOnFade``, ``PWMCT``, ``WhiteBlend``, ``VirtualCT`` as synonyms for ``SetOption37, 68, 82, 91, 92, 105 and 106`` respectively it would be great to connect for example some relay for domotic usage and having it cable by lan instead of wifi only Espressif have published some code for the TLK110. But it is relatively expensive (around 6 EUR when bought in small quantities) and is relatively big as it has an MII-interface which is not entirely needed. Power and mode must be individually controllable. Some devices may not function properly if the mode is also turned off when the power is turned off.I have copy and pasted template {"NAME":"WT32-ETH01","GPIO":[1,1,1,1,1,1,0,0,1,0,1,1,3840,576,5600,0,0,0,0,5568,0,0,0,0,0,0,0,0,1,1,0,1,1,0,0,1],"FLAG":0,"BASE":1} When STM become officially supports external PHY Ethernet, I will delete this repository. Hardware requirements Microchip's LAN8710A/LAN8710Aiarehigh-performance, small-footprint, low-power 10BASE-T/100BASE-TX transceivers specifically designed for today's consumer electronics, industrial and enterprise applications. The LAN8710A/LAN8710Aiarethe industry's smallest footprint solution with up to 40% lower power consumption than existing Microchip transceivers. The LAN8710A/LAN8710Ai have an integrated voltage regulator and ESD protection components to help reduce Bill of Material (BOM) costs. Is it normal? Why I can't have Ethernet connection without wifi connection? Then what is the point having Ethernet connection?

In the future, Ethernet support using external PHYs will change significantly and support may change. HP Auto-MDIX eliminates the need for special "crossover" cables when connecting LAN devices together.Remove the two jumpers from CN2, and place them at the two outermost empty jumper pins marked CN11 and CN12. Example configuration entry ethernet : type : LAN8720 mdc_pin : GPIO23 mdio_pin : GPIO18 clk_mode : GPIO0_IN phy_addr : 0 # Optional manual IP manual_ip : static_ip : 10.0.0.42 gateway : 10.0.0.1 subnet : 255.255.255.0 Configuration variables: ¶

For using the thermostat function, publication of the measured temperature was using the wrong name. Changed to the common used name.TheLAN8720A/LAN8720Ai connect via an RMII interface.These devices support HP Auto-MDIX†, employ Microchip's proprietary flexPWR ® technology andare available in both extended commercial (0°C to 85°C) and industrial (-40°C to 85°C) temperature range options. iBeacon (xdrv_52): Clean up BLE_ESP32 based driver; add commands and advert timing. Remove HM10 code - it's in the other one.....