About this deal
Or is it possible to turn a julet style controller compatible with a higo hub (of course with some soldering)? Anyone tried this? I'm looking for an Hailong inner controller to run this hub. I've seen some but with julet plug. I don't know which type are those from topebike, i'll ask them. I don't have any controller for the moment and no display. Just trying to find an inner controller for hailong battery. They always come with a KT controller inside. Supposedly the sensor connector has “standard waterproof” connector but I can’t seem to find any cable with matching female 3-pin connector anywhere. There are plenty of 9-pin motor cables on usual ebike shops but no 3-pin cables.
3 Pin Connectors | CPC UK
Shed No. 2, Gali No.1 Shahupura Industrial Area, Sector 63, Ballabhgarh, Faridabad - 121004, Dist. Faridabad, Haryana No 46/1, Vittal Nagar, Near Muneshwara Temple,, 2nd Cross, 2nd Main, Bangalore,, Bengaluru - 560018, Dist. Bengaluru, Karnataka Plot No.46/1 1st Floor Cie Extension Gandhi Nagar Balanagar, Balanagar, Hyderabad - 500003, Dist. Hyderabad, Telangana Cotic Roadrat built up from scratch. Bafang G370 front hub in steel surly forks and rear alfine 8 hub gears.B-15, Mangol Puri, Industrial Area, Phase-II, Mangolpuri, New Delhi - 110034, Dist. New Delhi, Delhi First Floor, Chah Indara, Bhagirath Palace, Chandni Chowk, New Delhi - 110006, Dist. New Delhi, Delhi Boardman cx/mx (1) Oxydrive kit(270rpm ). (2) Bafang cst & KT kit (270rpm), (3) Q128C & KT kit( 201 rpm)), (4) Yose CST & KT kit (270rpm). The motor cable exiting the hub axle is nowadays a 8 or 9 pin one 3 large phase pins and 5 or 6 thinner hall pins. These are a standard layout what ever the make/brand on them. Considering your reply above ( january 20), now the wire pin out sequence is quite often the same and things have changed since you wrote it?
Waterproof Connectors - Seaware Waterproof Connectors - Seaware
Well I am not using a throttle and the throttle connector coming from the controller is the male JST 3-pin that matches the female PAS connector. Now I am thinking of cutting off the throttle connector with enough wire, cutting off PAS connector, soldering those wires together, then plugging that into the PAS connector on the controller. At least that way I can still disconnect the sensor without cutting the soldered connections.No. 56, Pushpak Cascade, Swathi Road Shanti Nagar, Shanti Nagar, Bengaluru - 560027, Dist. Bengaluru, Karnataka