KnitPro KP10878 Rainbow Knit BLOCKERS PK20, Assorted

Product Information

I aim to reassure you too, that it’s not as intimidating as it can seem. And in addition to my normal disclaimer, as I so often find in crochet, there is rarely only one correct approach.

Ideally you would use a garment steamer because you have more control, however a steam iron can work if you hover it an inch or so above the fabric. It’s important not to work too close to the fabric and not to apply direct heat to the fibres.Avoid wringing, twisting, or distorting the fabric as you take it out of the water. Once placed, let the garment dry completely before moving it.

It’s a fine line between using heat to ‘break’ and manipulate acrylic fibres and irreversibly flattening it. Never apply direct heat to any yarn. It can melt the acrylic fibres or flatten the stitches, irreversibly damaging it. Never place a hot iron onto your fabric, you may end up with quite the mess.

You may also like…

It is also used to evenly shape pieces; whether they are panels for a sweater or simple granny squares, finished items look a whole lot better if their parts are neatly shaped.

Throughout the instructions, I have given some guidance about the best method for different fibres but I wanted to take a moment to clarify this.

In the pictures I am using knit pro T-pins which are super sharp (so please take care!), robust and easy to use, however any rust-proof dressmakers pins should work too. Water – you can soak your project in a clean bowl, basin, sink or bath, and you may also find a simple spray bottle useful Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie. Once the yarn feels moist and relaxed, remove the protective cloth and position the garment according to your knitting pattern. Follow the pinning instructions above to fix it in your desired size and shape. 4. Leave to Dry

If the project is exactly the size you need it, avoid stretching it – just lay it flat and smooth any bumps down. 5. Remove the Pins If you have any particularly large holes, uneven stitches, or mistakes, pull on the surrounding stitches to distribute the yarn more evenly. Once you have the pins in the centre of the sides, continue to evenly shape the fabric, then you can add the pins in the corners. Some purists might say absolutely, but honestly I don’t think it’s necessary in every project. It really depends on what it is and what it’s going to be used for. An easy way to start is to place your first pin at the top of the garment in the center. Stretch the work to your desired length, then place your second pin in the bottom center. Next, add two more pins on each side and pin to your chosen width.The next pin(s) should go half way across the gaps between pins and so on until you have your straight edges. Lay your knitting down on the surface with the right-side facing up. Begin carefully stretching the fabric to fit the size and shape you need. If you plan to pin your knitting in place, choose a cushioned flat surface like a yoga mat, ironing board, bath mat, cushion, carpet, or a bed. If your project is small enough, you can even use a corkboard. In this section, we’ll teach you how to steam your fabric and then pin it, so the yarn is pliable first. As the fabric dries, it will retain the size and shape it was pinned to. 6. Seam the Pieces Together