Nartel® 10 X 1 AMP SHAVER FUSES BS646 1AMP MINI FUSE 20MM X 5MM

Product Information

Zone 1 – the area directly above zone 0, limited vertically to 2.25m above the bottom of the bath or shower, also 1.2m horizontally from the centre of a shower outlet to the height of the outlet, or 2.25m whichever is the higher Unfortunately most stores only carry the first two categories and often provide poor information about what they are suitable for A Rating Ideal for all Applications - 3A for up to 720W, 5A between 720W and 2100W, 10A between 2100W and 2400W, 13A between 2400W and 3120W

Shaver Plug Adaptor UK, Two Pin Plug Adaptor UK To 3 Pin Shaver Plug Adaptor UK, Two Pin Plug Adaptor UK To 3 Pin

As we have mentioned above, when running down a wall to a power supply unit such as this the cable will need to run vertically down in a straight line to comply with regulations. All wires are then set into the wall and capped with protective sleeving and then all chases are filled, smoothed off and the either painted or tiled over. shaver adaptors: (e.g. http://www.maplin.co.uk/Module.aspx?ModuleNo=1186&DOY=31m3#features) theese are designed for shavers and can also be used for other very small <1A appliances that do not require earthing and come with a two pin europlug (a relatively thin plug with two thin flexible pins). They are NOT suitable for either applicances that require higher currents or those that require earthing

Different Methods of Wiring a Shaver Socket

However if you are installing in an upstairs then you may be able to locate a suitable supply in the loft. This is often the easiest route as everything should be much more accessible. The cable is then normally capped (covered with a protective UPVC capping) or run through some UPVC trunking/pipe to protect it and hold it in place. Zone 0 – the interior of the bath or shower which can hold water. No appliances should be installed here period!

Masterplug 3-Pin Fused Shaver Adaptor - Screwfix

Once all the wires have been connected, the face plate is then screwed on to the pattress box, fixing it in place. Once a suitable supply has been found the next task is to isolate the supply to the circuit you are using! If in any doubt, the power to the entire house is turned off. Once this is done, a minor works certificate is then issued to prove the installation has been carried out correctly.visitor adaptors (e.g. http://www.roamingfox.co.uk/UK-Visitor-Travel-Adapter-pr-16228.html ). Theese have a higher current rating than shaver adaptors and can be used with some earthed plug types. However THEY WILL NOT PROVIDE AN EARTH TO GERMAN/DUTCH/FRENCH plugs. If no supplies are this conveniently placed then it may be that you have to take up some floorboards in an above room and run your supply from here. Zone 2 – the area beyond zones 0 and 1, 0.6m horizontally and up to 2.25m vertically. Zone 2 also includes any recessed window with a sill next to the bath and also around the wash basin In both cases, the cables are run down through the ceiling and down a chase cut into the wall to run to both locations Wall chased out and cable placed in chase and protective UPVC pipe Step 3 – Install Fused Connection Unit (FCU)