So far I couldn’t find birdies anywhere on the D-808. The PL-660 is pretty clean on shortwave too, but it has hefty birdies around 100, 200 and 970kHz, despite the efforts Tecsun has put into shielding and clean PCB design. Now since yesterday I own such a radio, and I’ve noticed it has aspects that are superbly resolved, but I miss a complete Instruction Manual. The pdf you have there (the same as the printed one that came with my radio) isn’t describing some matters, I will highlight just those I’ve confronted:

There is no tone control, nor a Local/DX switch. The display is smaller than I would prefer. I want the frequency to be f Portable SW radios might be a highly niche product now but given the technology available and how long Sangean has been making radios, there’s no excuse for some of their choices or the missing “wow” factor I got as I scanned through the SW bands. What about single sideband? These four videos show reception in AM mode only, but rest assured the D-808 is very capable on the SSB modes of LSB and USB! A separate fine tuning rotary wheel on the right side of the radio’s case offers adjustment in 10 Hertz increments. The effect feels very similar to tuning CountyComm’s GP-5/SSB “walkie-talkie” style receiver. The plus or minus (+/-) offset is displayed in multiples of 10 Hz steps as “-1”, “-2”, “-3”, and so on. To “a newer and faster DSP chip to speed up mode changes”: The D-808 is a Si4734/Si4735/Si4732 chip receiver. Other radios of this type are the very cheap chinese ATS-20 and ATS-25 or the well known brands radios Tecsun PL-310ET, PL-365, PL-360, PL-380, PL-880, Degen DE1103 DSP, DE1123, DE1126, Sangean ATS-909X, C Crane CC Skywave and Radiwow R-108.Shortwave Single Side Band (SSB) minimum step is 1 kHz, Upper Side Band (USB) and Lower Side Band (LSB) reception independent I have recently bought the xhdata D808. It has significant hiss at zero volume through headphones. Fortunately the hiss is constant and does not increase with volume.

Due to product quality problems within 3-12 months of receiving the product,we can repair it for free, but the customer pays for the logistics costs incurred. The Upshot: Well, there’s no doubt that the latest model is slightly less desirable for hard-core DXers who chase down very weak AM signals in very low noise locations although it is preferable to the interim model which had that residual hiss. I don’t think however that the difference will an issue to program listeners. On SW the newest model is equal and perhaps just slightly better than my original D-808. FM is unchanged and still excellent…I did not test LW. I have to think that it is highly unlikely that there will be a new version of the D-808, unless someone out there has heard something in the receiver rumor mill that I have not. Perhaps the folks at XHDATA/RadioWOW will take this hint.As mentioned above, signals can increase quite a bit in very close proximity to the water. When conditions were good, I’ve witnessed occasional overloading even with just the whip antenna on the PL-660 there. But the Tecsun has a 3-position sensitivity switch that first turns off the input amplifier and then adds an attenuator, so it can manage these situations by turning off the preamp and it happily digests signals from full size dipoles, long wires and active antennas with the built-in attenuator in the signal path. The second pair of digits is a crude calculation of receiver (not audio!) SNR, which can be useful in conjunction with the signal strength meter, e.g. for adjusting or comparing antennas and so on, and it works best with AM and FM signals. FM stereo / MW / LW/ SW SSB and Air Band radio with high sensitivity, good selectivity, and user-operation friendly

Using the D-808 again after a few years reminded me that this little China-made receiver offers no less than SEVEN bandwidths, in AM mode. Let me say that again: SEVEN (7) bandwidths. Audio. I find the D-808’s audio quality to be slightly more mellow or warmer…I like that, especially on FM! Audio on the MW and SW bands still has a crispness that aids in DXing on those bands, however.The PL-660 is poor on LW and Deaf on MW great on SW and has great Sync Detection I wish other radios had, the wider filters can be an issue with SW DX’ing but changing to LSB/USB can make all the difference. Other than that, it seems to abide <10m/30ft of wire just fine and it gets along with my ML-200 active loop, currently indoors with a rigid 80cm aluminum loop, unless the RRI transmitters populate 49 and/or 41m after midnight. That station occasionally hits the 9+60 mark on my SDR with a dipole and when they’re on, the D-808 has to be tuned far away from these bands or disconnected from the loop to stop the pumping, desensitizing and intermodulation products. Interestingly, strong signals often make the filter drop out (as described under “SSB reception”) as well. A theory could be that this happens when an off-band signal (and/or the AGC causing “clipping”) makes an AD-converter run out of bits. For anyone interested making a LW induction antenna as shown above, here is a link to a video that has basic instructions & further results. It may be a very simple build & finish what I did, but for me the most important thing is that it works.