User tip: If you’re using our multifunctional tabletswhich already contain algaecide, you should only dose your pool with 1 litre of algaecide for every 10,000 gallons of pool water at the start of each season. After that initial dose, the multifunctional tablets will supply sufficient algaecide to help prevent algae from getting established. Following this, you can use the chlorine dosing calculators to work out the required chemical dose to increase the amount of chlorine in the water. Application Instructions 1: Pre-dissolve the product in a clean plastic container at a maximum rate of 100g of product per 2:2 gallons (10lts) of clean warm water Split this total amount into 4 smaller doses. Apply each 1/4 dose, allowing time to thoroughly circulate (2-3 hours for commercial pools / 6-8 hours for domestic pools) before re-testing chlorine/bromine level and if necessary adding further doses. Our most popular algae treatment, polyquat algaecide,is absorbed by organic debris such as leaves and dead algae, so it‘s important to clean the pool thoroughly with a brush or vacuum cleaner before starting the chemical treatment.

Not to worry, we’re going to cover the 4 best methods to lower your chlorine level, starting from best to worst. This is exactly what it sounds like; a chemical that reacts with chlorine, breaking it down and effectively rendering it useless. What’s more, commonly used neutralizers work in as little as a few hours. Proper testing. Always get an accurate read on your chlorine level before adding more to your water. Consider investing in a liquid testing kit for the most reliable results.

User tip: for 20-gram tablets, fill up the floating dispenser and adjust the collar accordingly. The tablets will take 5-7 days to dissolve. Credit subject to status and affordability. Terms & Conditions Apply. Hot Tub Suppliers Limited, 11 Midland Street Leicester LE1 1TG FRN: [654375] is a credit broker and is Authorised and Regulated by the Financial Conduct Authority. Never mix with any other chemicals including cleaning products and chlorine products, as a dangerous reaction will occur. There are two types of chlorine available to use as sanitisers. These are stabilised and unstabilised chlorine. Stabilised chlorine The easiest way to go about introducing more contaminants to your pool is to go for a swim. Natural body oils like sweat and saliva have a measurable impact on your chlorine level, especially if you can get more bodies involved.

It is very difficult to give an exact amount of calcium hypochlorite required to clear a green pool but as a guide: User tip: 1kg of alkalinity builder increases the alkalinity level of a 10,000 gallon pool by 12ppm. This can be added directly to the pool and dissolved using a pool brush. Calcium hardness – what does calcium hardness do to a pool?

Be careful not to overdose the chlorine remover, or you’ll have to once again reverse the process and add chlorine to get the water to a suitable chlorine level – which will mean unnecessary labour and cost to you. Automatic chlorination. Alternatively, an automatic chlorine feeder controls when and how much chlorine gets into your water, so you never have to worry about accidentally adding too much to your pool. Do not pour this product into a pool skimmer basket containing chlorine tablets or any other product. We advise you to obtain a correct level of total alkalinity (70-160 p.p.m) and then add small quantities of pre-dissolved pH Increaser (Sodium Carbonate) or pH Reducer (Sodium Bisulphate). Reason for Testing: To allow Chlorine to work to its full potential and to prevent any corrosion or scale forming it is important to maintain a pH within the ideal range. The correct pH level also provides comfortable bathing conditions for the bather as it reduces the chances of irritation occurring.