This is the hard part. You are expected to wait 24 hours after all of this hard work so the silicone can set. Step Thirteen Tape around the edge of the tube. This will be pressed against your body so you want it to be smooth. My fantastic confidence in this endeavor and product waned considerably when I unfurled the poster-size directions. The four simple steps had transformed into more than a dozen, and the incredible specificity of each step had me in an immediate state of panic.

Though it took forever, pouring the molasses-like substance into the mold was not unlike watching the slime fall as the credits rolled in the Goosebumps series.Technically, the water is supposed to be 90°F, but I pulled an amateur move and just measured out some hot water, hoping for the best. Using the clone a willy strapon is straightforward. First, you’ll need to measure your partner’s penis and select the correct size of the molding tube. Next, you’ll need to prepare the molding powder and add it to the molding tube. Then, you’ll need to mix the two-part platinum-cure silicone mix and pour it into the molding tube. Finally, you’ll need to let the dildo set and then remove it from the mold. Look for a kit that comes with a range of different colors and textures. This will allow you to customize your dildo to your specific needs.

However, do note that the free standard edition only supports a data disk clone. To clone a disk including a Windows system, the disk style (GPT/MBR) of the source disk and the destination disk must be the same. Clone-A-Willy recommends that you do this project over a hard easy to clean surface, and I couldn’t agree more. The first time some managed to get on a towel. There was no getting it clean. Pour out any water that has accumulated in the bottom of your mold and slowly pour in the silicone. I texted James to see if he’d had success. Nope. He, too, struggled with the molding mixture, and his curved penis kept touching the sides of the tube. (If he’d been less impatient, he would’ve seen that the Clone-A-Willy kit offers a solution for men with curved penises.) After you dig yours out, you are going to want to wash it with soap and warm water, especially if you plan to use it.In lieu of a Valentine’s Day gift, I wrote my girlfriend a letter explaining what I’d gone through. I finished the letter with, “I tried, I failed, but I will not give up. I need your help, my love.” The first thing you’ll need to do is measure your penis to get the correct size of the molding tube. Once you’ve done that, you’ll need to prepare the molding powder and add it to the molding tube according to the directions. Next, you’ll need to mix the two-part platinum-cure silicone mix and pour it into the molding tube. Finally, you’ll need to let the dildo set and then remove it from the mold. Benefits Of Using A Penis Mold Dildo