T RIM M ODE E DGE M ODE T URN OVER TO E DGE TIO A M R NFO I T TA N se R O ence r P u e f e M e r I befo future r d a e R n for i a t e &r N Double Auto Feed System How the automatic line feed works (F) 1. When initially switching on the trimmer, a small length of line is fed out. 2. A ‘clattering’ noise will be heard when the two nylon lines hit the line cutter. DO NOT BE ALARMED this is quite normal. After approximately 5 seconds the line will be cut to the correct length and the noise will reduce as the motor reaches full speed. • Make sure the motor is up to full speed before trimming or edging. 3. How the automatic line feed works (F) 1. When initially switching on the trimmer, a small length of line is fed out. A `clattering' noise will be heard when the two nylon lines hit the line cutter. After approximately 5 seconds the line will be cut to the correct length and the noise will reduce as the motor reaches full speed. · Make sure the motor is up to full speed before trimming or edging. If the noise of the nylon line being cut cannot be heard, more line will need to be fed out. To feed more line, it is first necessary to to allow the motor to stop completely, then re-start, allowing the motor to reach full speed. until you hear the lines hitting against the cutter. (Do not repeat this procedure more than 6 times) 6. If problems are experienced with the automatic line feed refer to Fault Finding Chart. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your trimmer. 6. Keep the cable clear of the cutting area and obstacles at all times. 7. Do not pull cable around sharp objects. 8. In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.