The main things you should be looking out for when choosing a circular saw are cutting capacity, cutting depth and bevels. The capacity and depth of your cut with a circular saw is based on the size of the saw’s blade. In the case of our cordless circular saws, the blade is a standard 165mm. This is arguably the most common size for circular saw blades. The 7 ¼″ is large enough to handle most jobs while being small enough to be portable and lightweight. inch circular saw can cut up to 2 ½ inches deep at a 90-degree angle. When cutting at a 45-degree angle, the depth capability decreases to 1 13/16 inches. The actual size of a 4″ x 4″ lumber is 3 ½″ x 3 ½-inches. If you want to cut through a 4×4 in a single pass, use a 10 ¼ inch circular saw. Although this saw is heavy, it can be very handy in situations such as cutting the top of fence posts that are already installed. Largest Circular Saw

Footplate: Also known as the shoe, this base plate stabilizes the saw against the workpiece and can be adjusted to vary the cut depth.

Where are you?

To adjust the depth of cutting on a circular saw, start by powering off the tool and locating the depth adjustment knob usually found near the blade on the saw’s body. Make sure the saw is unplugged, and then loosen the adjustment knob. The most common type of circular saw is the Sidewinder. This device has the motor on the same axis as the blade. The motor moves the blade thanks to a shaft that extends outward and makes a solid connection. The result is a powerful saw that is relatively easy to maintain and use. So far, we’ve only looked at common table saws with a blade diameter of 10 inches (254mm) and lower, and none of them can cut deeper than 4 inches (101.6mm). But since we did mention table saws with 12-inch (304.8mm) blades and their ability to cut up to 4 inches (101.6mm) deep earlier, you might be wondering if that’s the limit in terms of the blade size and depth of cut. When trying to figure out what size of blade you need, the best starting point is to look closely at your circular saw. inch circular saw offers a slightly deeper cut, with a maximum depth of 2 1/8 inches at 90 degrees. At a 45-degree angle, the cut depth is 1 7/8 inches.

Meanwhile, the R4514 Pro comes with maximum cut depths of 2-¼”(57.15mm) and 3-½” (88.9mm) for 45-degree and 90-degree cutting angles, respectively. Last but not least is the 13 Amp R4520, which can cut up to 2-¼” (57.15mm) deep at a 45-degree angle and 3-¼” (82.55mm)deep at a 90-degree angle of cut. Ryobi Table Saw Cut Depth

Cookie Notification

If there is a blade then it will be easy to find the exact size. However sometimes that has worn off. That makes it slightly harder to figure out.

We’ve tested the three main types of saws here – corded, cordless, and a mini circular saw – covering all-round useability, the accessories included, the noise when the saw is spinning freely and during a cut, and, of course, its ability to cut wood.

My Top Recommended Mini Circular Saws

The motor on a circular saw is liable to be placed under extreme stress if you’re cutting long pieces of hard timber. So look out for safety features built into the motor, such as protection against burning the motor out, fans to keep the motor cool or advanced braking systems that immediately kill the motor and stop the blade in an emergency.