We sell mower cables including drive cables, throttle cables and electric mains cables for many lawnmower makes including AL-KO, Flymo, Hayter, John Deere and more.

Throttle Cables | Mower Cable | Revs | Genuine Lawnmower Throttle Cables | Mower Cable | Revs | Genuine

This method is easy and pretty effective- the main issue is the ghastly lump in your cord that you'll be left with afterward! Align and insert both of your cables within the aluminium crimp (or any other correct sort of connector) simultaneously- seal by striking the flatter edge of the crimp with your hammer. This method is perhaps the one many people opt for first. It involves shortening the wire slightly, and reconnecting it with a wire nut, then sealing it up with electrical tape. Clean up any wire, and slide some heat-shrink tubing onto one end of the wire- space these far away from the wire ends to prevent premature shrinkingAfter digesting all the comments and advice, I have decided not to touch the wiring in the switch and will cut the existing cable about 18" from the switch and then add the new extended cable using the orange rubber plug connector. All Mower Parts UK supply genuine and non genuine replacement lawnmower throttle cable and throttle assemblies, for petrol lawnmowers, petrol rotary lawnmowers and petrol cylinder lawnmowers

Masterplug NC102O 10A 2-Pin Connector Orange - Screwfix

This technique is slightly more advanced but highly preferable to the other methods mentioned. Soldering typically involves the use of a soldering iron and solder. Add on another crimp (or any suitable connector) on your new, extended cable. Loop the remainder of the cable through the original gap where the S-shaped part went. Run through the other end of your new cable into the aluminium crimp to close it off. This attaches the extended cord to the pull bar.

Now that you've fixed it, you need to test it and ensure it's safe and working. As the severed ends of the crushed cables will be sharp, we recommend cutting them off.