After stripping and rinsing. All porous surfaces must be immediately treated with Net-trol while still wet to neutralise the surface. Clean up Recommended application: for best results surfaces must be clean, dry and free of loose dirt. Approximate Coverage Wet surface with fresh clean water. Apply Owatrol Net-Trol with a stiff scrubbing brush working in to rust stain. Leave to work for 10 minutes. Re-scrub surface with a stiff scrubbing brush. Rinse with large amounts of fresh clean water.

Brush off any physical surface contamination i.e. moss, general dirt etc Application Removal of oils and millglazeIt will save both time and effort when cleaning and restoring colour to wood by effortlessly removing both the surface and ground in dirt in as little as 15 minutes without the need for sanding. Net-trol is also biodegradable and does not contain solvents or bleach meaning it’s not harmful to plants and shrubs so it’s safe to use in the garden. Easy to apply, Dilunett dissolves paint in even the smallest of recesses and the finest of details, softening all the layers for a simple and clean removal. Scrub surface with a stiff nylon/synthetic brush whilst rinsing with water or use a pressure washer (max. 60 bar). Dilunett is our amazing solvent free paint and coatings remover. It is powerful enough to remove up to 8 previous coatings in just 1 application! It’s ideal for stripping large areas as Dilunett is non-flammable, does not dry out and remains active a long time. Clean weathered wood with Net-Trol, to remove the loose wood fibres, dirt and other surface contaminants. If the wood is severely contaminated, clean it with Aquanett and neutralise with Net-Trol. Previously oiled surfaces

Net-Trol is a powerful wood cleaner and brightener. Grayed and weathered wood can be restored to its natural color with Net-Trol, without damaging the wood’s fibers. It effortlessly removes both surface and ground-in dirt leaving the wood looking bright and vibrant. Shake or stir container well before use. Use neat or diluted. See data sheet. Work large areas in zones. Always work in the direction of the grain. Do Not use a wire brush. Leave to stand for approx 10-20 minutes. If the surface starts to dry, dampen with a mist application of water Exterior – Prepare as for interior wood or treat the surface with Aquanett and then neutralise with Net-Trol. Always read the Dilunett Gel Product Information before using and follow the instructions carefully.

After stripping and cleaning, allow the wood to dry for 2-3 good drying days before applying Deks Olje D1. D1 may only be applied to bare wood surfaces or a weathered wood surface that was previously finished with Deks Olje D1. All other finishes must be completely and thoroughly removed first. If necessary sand the surface after cleaning and/or stripping (100 grit paper). New wood Deks Olje D1 must be kept ‘active’, this is done by the ‘wet on wet’ applications and the continual brushing over of the area, which assists and helps achieve maximum penetration. D1 has high penetration; its place is in the wood and not as a surface coating. Allow 3 days for D1 to set-up and dry, before use or in marine uses before putting the boat in service or continuing with Deks Olje D2. Temperature is of very little importance when applying D1. Clean Up Dilunett is a solvent and paraffin free paint stripper that will remove any oil and alkyd based paint, varnish or woodstain. Dilunett’s powerful formula strips up to 8 coats of finish in just one application. Suitable for almost any surface such as wood, metal and plastic, Dilunett’s gel consistency means it will not run, making it ideal for us on vertical surfaces, elaborate plaster or wood designs that are in need of being stripped.

It is safe to use on all exterior wood types and is also an excellent degreaser for use on tropical hardwoods to allow finishes like Deks Olje D1 to penetrate. Net-Trol can remove stains caused by tannin bleed and will remove all traces of weathering caused by mildew, pollution and UV rays. Why should I use Net-Trol? Otros soportes: cemento oxidado, piedras con moho, plásticos polvorientos. Consejos para una aplicación correcta We hope you found this post on how to clean rust stains from your patio interesting. If you have any other advice or top tips, please feel free to leave them in the comments below. We love hearing from you!Ideal for stripping large areas as Dilunett is non-flammable, does not dry out and remains active a long time. Leave the Net-Trol to stand for approximately 15 – 20 minutes. If the surface starts to dry, you must moisten it again by using a spray of mist application of water. Can be used on most surfaces; on wood (some woods such as Oak and Chestnut require more attention before using Dilunett), metal (except Aluminum), plastic, stone, cement etc